Polymer Latex Waterproofing Coating

Polymer Latex Waterproofing Coating

1. Introduction of product Polymer latex waterproof coatingis a single component product. It is made from pure acrylic emulsion, styrene-acrylic emulsion and other additives. At application, the product is supposed to be mixed with cement and sand by a proper ratio. The mixture, after applied to...

Product Details

Polymer Latex Waterproofing Coating

1. Introduction  of product

 Polymer  latex waterproof coatingis a single component product. It is made from pure acrylic  emulsion, styrene-acrylic emulsion and other additives. At application, the  product is supposed to be mixed with cement and sand by a proper ratio. The  mixture, after applied to substrate surface, will then solidify and form a  dense waterproof layer.


2. Property  of product

  • The product is applicable to damp substrate, the  construction is relatively easy.

  • The product has good bonding strength and ideal  workability.

  • The product has good resistance against aging and erosion,  good adaptability to temperature change.

  • The product is a non-toxic material, safe to use and  eco-friendly.


3. Instructions  of product

  • Application surface need to be solid, flat and clean.

  • Defects on the application surface, like honeycomb and  crack, need to be filled and smoothened. Corners need to be filled and rounded  off.

  • At application, the product ought to be mixed with cement,  mixing ratio is 1:0.8(emulsion: cement). When doing this, keep stirring to get  the mixture into a uniform state. Then construction can be executed. Use up the  mixture within 60 minutes.

  • Recommended usage amount is 1.8kg/㎡ for a 2~3mm thickness.


4. Attentions

  • Do not blend in the product with water if it is not to be  used soon.

  • Use ordinary Portland cement, 325# and above, for the  blending.


5. Where  to use

  • Various places in a building, like basement, bathroom, roof  and exterior walls.

  • It can also used on air brick walls, aerated concrete  structure for moisture proofing.


6. Product  storage

  • The product shall be stored in a cool dry place, ideal  storage temperature is above 5℃.

  • Under normal condition, average storage life of the product  is 12 months.

Inquiry